Sor Mini-Hermet Manuel d'utilisateur télécharger pdf

Form 1296 (05.13) ©SOR Inc.

1/4

These instructions cover installation, process connection, electrical connection

and calibration of the SOR

Pressure Switches for Fire Protective Signaling

with Hermetically Sealed Electrical Switching Elements

The static-o-ring type Pressure Switch is suitable for a wide variety

of process applications.

Pressure Switches for

Fire Protective Signaling

General Instructions

Registered Quality System to ISO 9001

NOTE: If you suspect that a product is defective, contact the factory

or the SOR Representative in your area for a return authorization

number (RMA).

Installation

This product should only be installed by trained and competent personnel.

The pressure switch may be line mounted to either rigid process piping or

electrical conduit. The body of the pressure switch should be clamped in

the area between the set point adjustment protrusion and the pressure

port to a suitable member on applications when rigid process piping or

electrical conduit is not available.

Design and specifications are subject to change without notice.

For latest revision, go to sorinc.com

connection

ignaling

rsonnel

iping or

ped in

sure

Process Connection

Use two wrenches when connecting process pipe: an 1-1/8 inch open-end wrench to hold

the hex port while connecting the process pipe; the other wrench to tighten the process

pipe or tube fitting.

When rigid process piping is used, it is important that no bending or torsional

forces be imposed on the pressure switch.

1 2 3 4

Résumé du contenu

Page 1 - Fire Protective Signaling

Form 1296 (05.13) ©SOR Inc. 1/4These instructions cover installation, process connection, electrical connection and calibration of the SOR® Pressure S

Page 2 - Electrical Connection

2/4Form 1296 (05.13) ©SOR Inc. Do not use a pipe wrench or strap wrench on the round body nor an open-end wrench on the hex pressure port while tighte

Page 3 - Dimensions

Form 1296 (05.13) ©SOR Inc. 3/4DimensionsDimensions are for reference only.Contact the factory for certified drawings for a particular model number.*1

Page 4 - Ordering Information

4/4Form 1296 (05.13) ©SOR Inc. 14685 West 105th Street, Lenexa, KS 66215  913-888-2630  800-676-6794 USA  Fax 913-888-0767Registered Quality