Sor Vane Operated Flow Switch Manuel d'utilisateur télécharger pdf

Form 588 (04.13) ©SOR Inc.

1/4

This device is intended as a flow/no-flow device only. It is not recommended

for use as an accurate measurement device. The 900 Series Flow

Switch is designed for vertical mounting only.

900 Series

Flow Switches

General Instructions

Registered Quality System to ISO 9001

Design and specifications are subject to change without notice.

For latest revision, go to www.sorinc.com

NOTE: If you suspect that a product is defective, contact the factory or

the SOR

Representative in your area for a return authorization number

(RMA). This product should only be installed by trained and competent

personnel.

Installation

Step 1 - Vane Length

Vane clearance is critical for proper operation of the switch. In order

to ensure this clearance, the following procedure should be followed:



Measure “C” on the existing pipe run (See

on page 2).



Trim vane (if necessary) to ensure a minimum of 3/16” vane clearance

when installed. Allow for thread engagement.

Step 2 - Installation



Thread bushing into pipeline coupling and align arrows in direction of flow.

(Arrows are located on fitting.)

Step 3 - Flow Adjustment

The flow rate on each switch may be externally adjusted following this procedure:



Remove the switch housing cover.



Remove the hex head plug located at the end of the enclosing tube

(See

on page 2).



Adjust the switch adjustment screw to the flow required. To increase switching flow

rate, turn screw clockwise. Maximum flow adjustment is approximately 10 turns.

ten

der

ed:

clearance

If vane is removed from unit for trimming, proper re-assembly is essential,

keeping small vane in its original position (See

on page 2).

1 2 3 4

Résumé du contenu

Page 1 - Flow Switches

Form 588 (04.13) ©SOR Inc. 1/4This device is intended as a flow/no-flow device only. It is not recommended for use as an accurate measurement device.

Page 2 - Threaded connection shown

2/4 Form 588 (04.13) ©SOR Inc. Dimensions are for reference only.Contact the factory for certified drawings for a particular model number.The safety r

Page 3 - Electrical Connection

Form 588 (04.13) ©SOR Inc. 3/4Process ConnectionIntegrally mounted controls should be mounted with the vessel flange or nozzle within 3° of the vertic

Page 4 - Wiring Continuity

4/4 Form 588 (04.13) ©SOR Inc. Wiring Continuity14685 West 105th Street, Lenexa, KS 66215  913-888-2630  800-676-6794 USA  Fax 913-888-0767Re

Commentaires sur ces manuels

Pas de commentaire

Sor Vane Operated Flow Switch Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Capteurs Sor Vane Operated Flow Switch. SOR Vane Operated Flow Switch User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Capteurs Sor Vane Operated Flow Switch